MiSTer FPGA Case V2

Integrated DE-10, I/O Board and USB Board into single case. All sides of the case are printed flat to create clean surfaces.

I'm using M3x16 cap head screws on the top. These are the board layers and hardware in order from top to bottom: M3x16 cap screw IO Board M3x14mm male/female brass spacer DE-10 Nano Board M3x14mm male/female brass spacer USB board M3 nut or M3x8 female/female brass spacer to which I add the silicone covers the DE-10 came with.

UPDATE:

Added the Audio Port to the USB Side Wall. Added Side plates for USB v2.1, Side with larger SoG switch opening and Longer Buttons with more clearance. Light Pipes ID has been increased to Dia 5.6mm. Ensure your printer is tuned and not overextruding resulting in ID falling short. Optionally a 5.5mm drill can also be used to clean any extrusion start seams in the ID to better fit over the LED

UPDATE: 1/16/2022 - Added Digital I/O v1.2 Ports

Print Settings

Rafts: Doesn't Matter

Supports: Doesn't Matter

Resolution: .2

Notes:

Print in PLA